Click to enlarge Image is similar

• Switching of 4 outputs by means of the F keys F1 to F12 (DCC) or F1 to F4 (Mot).
• Neon effect: when switched on, the outputs flicker like a fluorescent tube (deselectable).
• Switching between 2 lighting levels
• 2 outputs can be switched depending on the direction of travel (typical case: driving trailer)
• Configurable switch-on delay

• Number of channels: 4
• Protocol: DCC, Motorola
• Length: 20 mm
• Width: 38 mm
• Height: 5 mm

This kit contains SMD components. However, soldering SMD components is much easier than expected ( 'Der richtige Umgang mit SMD' (Source: ELVjournal, German language)). You can also purchase this kit with partially preinstalled SMD components (see 'Available Options' below).

Construction manual, schematics and PCB layouts are delivered on a CD-ROM, including firmware (if applicable) and a great deal of additional information.

This kit comes with a pre-programmed processor.

Difficulty level:

Click the clipboard icon to check the recommended tools for this kit.

The standard version of this kit consists of these components:   » 1 x PCB "WeichZwei"         » 1 x PIC12F629-I/SN         » 1 x 78L05         » 2 x ULN2003         » 1 x 1N4148 (SOD-123)         » 1 x B40FS         » 2 x SMD resistor, 22 kΩ (1206)         » 1 x SMD multilayer capacitor 47pF (0805)         » 1 x SMD multilayer capacitor 100nF (0805)         » 2 x SMD multilayer capacitor 1µF (1206)         » 1 x SMD fuse, 2 A, rapid         » 1 x SMD shortstroke pushbutton